IrrigationCaddy (ICEthS1) Binaries

ICEthS1-1.2.99 (Official Release)

IrrigationCaddy (ICEthS1) ICEthS1-1.2.99 

Last Updated 7/27/2011   

FIXES:

• Calendar would never finish rendering if all three programs were active.

---

ICEthS1-1.2.91 (BETA)

IrrigationCaddy (ICEthS1) ICEthS1-1.2.91 

Last Updated 7/11/2011   

FIXES:

• Run Now program would not run. It would only run if triggered from a regular program.

---

ICEthS1-1.2.88 (BETA)

IrrigationCaddy (ICEthS1) ICEthS1-1.2.88 

Last Updated 7/9/2011   

FIXES:

• If no programs are enabled, and the "Calendar" link is clicked, the caddy would crash.
• The Run Now program displayed a "Save" button instead of a "Run Now" button

---

ICEthS1-1.2.85 (BETA)

IrrigationCaddy (ICEthS1) ICEthS1-1.2.85 

Last Updated 7/4/2011   

ENHANCEMENTS: 

• Added Multiple Starts for a program
• Added a "Run Now" button to every program. Pressing the "Run Now" button on a program causes the data for that program to be transferred to the Run Now program, and it is executed immediately.
• Added a "Program Summary" area on each program which reports the total run time for a program. The time updates as the zones are being updated. 

FIXES:

• Issue with time reporting 12AM when it is 12PM

 ICEthS1-1.1.347

IrrigationCaddy (ICEthS1) ICEthS1-1.1.347

Last Updated 3/27/2011 

FIXES:

• Over 60 minutes warning is not working. Pressing the cancel button would still allow the system to save the zone.
• Using single quotes on the zone names causes the User Interface to break. The programs would not render.
• Uninitialized zone names are not checked for bad chars.

NOTE:

If upgrading from versions older than ICEthS1-1.1.337, you will have to perform a RESET. Programming information will be lost, so make sure you note your settings before upgrading.

ICEthS1-1.1.337

IrrigationCaddy (ICEthS1) ICEthS1-1.1.337

Last Updated 2/21/2010 

ENHANCEMENTS:

• Added rain sensor status in the status area.
• Zone #10 can now be configured as a regular zone, and not just as a master zone.
• Added support for NTP (Network Time Protocol) time.

FIXES:

• HTTP Port numbers on the settings page would not save properly.
• The System OFF button did not work as expected. It would go OFF momentarily, but then return to ON.
• HTTP gateway on the settings page would not save properly.

NOTE:

After upgrading the firmware you will have to perform a RESET. Programming information will be lost, so make sure you note your settings before upgrading.

ICEthS1-1.0.259

FIXES:

• N/A